![]() Removal and installation using 20 ton bottle jack and hydraulic press.I u. Like I said, I haven't done this in years but I do not think the process has changed much. KingPin Replacement on Isuzu NPR-HD NPR NQR NRR or GMC Chevrolet W3500 W4500 W5500. KING PINS FOR A 1992 GMC 3500 TRUCK INSTALLInstall the new king pin and grease it up good and re-install the hub assembly and wheel. ![]() It has a wheel lift but we dont use it often so the levers are stiff. Install the new bushings making sure the grease hole is in the proper location by driving them in with the bushing tool. Start towing today, we use this regularly and needs nothing. If the bushings are wore through and the bosses are affected by this wear, you will need a reamer to ream out the bushing bosses so oversize bushings can be installed. Please note that the 90150 is not compatible with FL981 axles where the tie rod is cast. You will need a bushing removal tool the same size as the bushings in the axle and spindle bosses, hammer out the bushings. The 90150 works on straight and tapered king pins from 7/8 to 2 5/32. Spicer 328349 King Pin Kit 313.96 Hendrickson 60961-040 Bearing Kit 204.78 Hendrickson 58937-000 Kingpin Retaining Ri. Find a drift pin a little smaller than the king pin and try to drive the king pin out with a BIG hammer, if this does not work, you will have to heat the axle boss where the pin slides in with a torch to loosen it up and commence hammering again until it comes out. Put jack stands under the axle for support. ![]() Once you get the wheel off and the hub, you remove the locking ring or it might have a tapered bolt. 92-97 Ford Dana 60s are ball joint, 8圆.5, and have standard lockouts. Depending upon the amount of wear, it is a straight forward job with a lot of work sometimes. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |